Batch Mode - Honeywell Xenon 1900 User Manual

Reset Scanner and Base
Once the power level is set, you must scan the Reset Base bar code and
wait for the scanner to unlink and relink to the base. Once that is done,
scan the Reset Scanner bar code and wait for the base to unlink and relink
to the scanner.
Reset Scanner

Batch Mode

Batch mode is used to store bar code data when a scanner is out of range of its
base, or when performing inventory. The data is transmitted to the base once
the scanner is back in range or when the records are manually transmitted.
Note: Batch mode has limitations when using multiple scanners to one base. If
a cordless system is being used in "multiple link mode," where up to 7
scanners are to be connected to one base, some accumulated or batched
scans could be lost if scanners are constantly being moved in and out of
range.
Automatic Batch Mode stores bar code data when the scanner is out of range
of the base. The data is automatically transmitted to the base once the scanner
is back in range. When the scanner's buffer space is full, any bar codes
scanned generate an error tone. In order to scan bar codes again, the scanner
must be moved back into range of the base so data can be transmitted.
Inventory Batch Mode stores bar code data, whether or not you are in range of
the base. To transmit the stored data to the base, either place the scanner in
the base, or scan
buffer space is full, any bar codes scanned generate an error tone. In order to
scan bar codes again, the data must be transmitted to the base.
3 - 14
Transmit Inventory Records
: * : R E S E T _ . ³
Reset Base
(page 3-19). When the scanner's