Linking Process; Scanner Is Out Of Range; Scanner Is Moved Back Into Range; Out Of Range And Back Into Range With Batch Mode On - Honeywell Xenon 1900 User Manual

Linking Process

Once a scanner is placed into the base, the scanner's battery charge status
is checked, and software automatically detects the scanner and links it to
the base depending on the selected link mode.

Scanner Is Out of Range

The cordless scanner is in communication with its base, even when it is not
transmitting bar code data. Whenever the scanner can't communicate with
the base for a few seconds, it is out of range. If the scanner is out of range
and you scan a bar code, the scanner issues an error tone indicating no
communication with the base. In addition, your scanner and base can
sound an alarm if programmed to emit an alarm. Refer to
Alarm, page 3-11.

Scanner Is Moved Back Into Range

The scanner re-links if the scanner or the base have been reset or the
scanner comes back into range. If the scanner re-links, you will hear a sin-
gle chirp when the re-linking process (uploading of the parameter table) is
complete.
Out of Range and Back into Range
with Batch Mode On
The scanner may store a number of symbols (approximately 500 U.P.C.
symbols; others may vary) when out of range and then send them to the
base when back in range (see
You will not hear a communication error tone in this mode, but you will hear
a short buzz when you pull the trigger if the radio communication is not
working. Once the radio connection is made, the scanner produces a
series of beeps while the data is being transferred to the base.

Page Button

When you press the Page button on the base, the scanners associated with
that base will begin beeping (3 short and 1 long beep). If you pull the trig-
ger on a scanner that is beeping in response, that scanner will stop beep-
ing. If you press the Page button on the base a second time, all associated
scanners will stop beeping. See
about Page Button settings.

About the Battery

There is a danger of explosion if the batteries are incorrectly replaced.
Replace the batteries with only the same or equivalent type recom-
!
mended by the manufacturer. Dispose of used batteries according to
the recycle program for batteries as directed by the governing agency
for the country where the batteries are to be discarded.
Batch Mode on page 3-14).
Paging on page 3-8 for further information
Out-of-Range
3 - 3