Ej Roller - Epson Stylus CX1500 ME100 Service Manual

EPSON Stylus CX1500/ME100

4.3.13 EJ Roller

V External View
Notch
2
Figure 4-29. EJ Roller Removal
DISASSEMBLY AND ASSEMBLY
EJ Roller
Claw
1
V Part/Unit that should be removed before removing EJ Roller.
Document Cover / Panel Unit / Panel Housing / Scanner Unit / Housing Upper /
Main Board Unit / Housing Middle / Front Frame
V Removal procedure
1. Slide EJ Roller to the left side, then remove the claw extending from Housing
Lower (Inner).
2. Lift left side of EJ Roller, and then remove EJ Roller along notch in left side
of Main Frame.
If the EJ Roller's gear and EJ Roller Shaft are removed, make sure
C A U T I O N
that neither of EJ Roller Shaft hooks is damaged.
If either of the hooks is damaged, it should be replaced with a new
one.
After replacing EJ Roller with a new one, always apply oil G-58 to
A D J U S T M E N T
R E Q U I R E D
the specified portions.
T
Refer to Chapter 6,
Disassembly
Hooks
Figure 4-30. Hook of EJ Roller
Figure 6-13 (p.120)
Revision A
95