Epson Stylus CX1500 ME100 Service Manual page 120

EPSON Stylus CX1500/ME100
Driven Pully Holder
Figure 6-10. Lubrication
Front Frame
PF Roller side
EJ Roller side
Figure 6-11. Lubrication
MAINTENANCE
<Lubrication Point>
1. Shaft of Driven Pully
2. Sockets of Driven Pulley
Holder
<Lubrication Type>
Driven Pully
1. G-58
2. G-58
<Lubrication Amount>
1. φ1mm x 2 points
2. φ1mm x 2 points
<Remarks>
1. Use a injector to apply it
2. Use a injector to apply it
<Lubrication Point>
PF Roller and EJ Roller on upper
side of Front Frame
<Lubrication Type>
G-58
<Lubrication Amount>
1mm x 308mm x 2 points
<Remarks>
• Use a brush to apply it
• Make the height of the grease
and lubrication amount the same
on both the PF Roller side and
EJ Roller side.
Carriage Unit
EJ Gear
Overview
<Lubrication Point>
Bottom channel of Holder IC
<Lubrication Type>
G-58
<Lubrication Amount>
φ1mm x 1 point
<Remarks>
Holdr IC
• Use a injector to apply it
• Slide Carriage Unit to center and
lubricate.
Holdr IC
Figure 6-12. Lubrication
<Lubrication Point>
1. Teeth the EJ Gear
2. Socket on Main Frame
<Lubrication Type>
1. G-58
2. G-58
<Lubrication Amount>
EJ Roller
1. φ1mm x half around
2. Adequate dose
<Remarks>
1. Use a injector to apply it
• Rotate lubricated teeth to
lower side.
2. Use a injector to apply it
Figure 6-13. Lubrication
Revision A
120