Removing Memory Module - Toshiba Portégé M100 User Manual

User's Manual
9. Rotate the keyboard into place. Insert six small tongues on the front edge of
the keyboard into corresponding notches on the computer. Be sure the ribbon
cable lies flat and is not pinched.
10. Secure the keyboard with two screws.
11. Set the keyboard brace into its groove and press down to secure the latches.
12. Turn the computer upside down and replace the battery pack (refer to Chapter
6, Power and Power-Up
13. Turn the computer on and check the memory. Open the System Properties
icon in the Windows Control Panel and click the General tab.

Removing memory module

To remove the memory module, make sure the computer is in boot mode then:
1. Turn the computer off and remove all cables connected to the computer.
2. Turn the computer upside down and remove the battery pack (refer to Chapter
6, Power and Power-Up
3. Slide the display latch on the front of the computer to the right and open the
display panel.
4. Open the keyboard as described in the previous section and lift out the
insulator.
5. Push the latches to the outside to release the module. A spring will force one
end of the module up.
8-10
Figure 8-7 Seating the memory module
Modes.)
Modes.)
S
S A
LOT
B
LOT