Removing A Memory Module - Toshiba NB500 User Manual

1. Screws
9. Install the battery pack - refer to
10. Turn your computer over.
11. Turn the computer on and make sure the added memory is recognized -

Removing a memory module

To remove the memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
2. Remove the AC adaptor and all cables and peripherals connected to
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack.
5. Loosen the screws securing the memory module cover in place - please
6. Slide your fingernail or a thin object under the cover and lift it off.
7. Push the latches away from the module in order to release it - a spring
8. Grasp the module by its edges and remove it from the computer.
■
Downloaded from LpManual.com Manuals
User's Manual
Figure 3-9 Seating the memory module cover
1
2
Chapter 5, Power and Power-Up Modes, if required.
to confirmed it, Start -> Control Panel -> System and Security ->
System icon.
the Turning off the power
required).
the computer.
note that the screws are attached to the cover in order to prevent them
from being lost.
will force one end of the module up at an angle.
If you use the computer for a long time, the memory modules and the
circuits locating close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them. Or
you will get burnt if you touch any of them.
NB500/NB505/NB520/NB525/NB550D/NB555D Series
2. Memory module cover
Replacing the battery pack
section in Chapter 1, Getting Started if
1
section in
3-21