Loading Documents on the Document Glass
1
Make sure that documents are not set in the automatic document feeder (ADF).
2
Lift up the platen cover.
3
Place the document face down. Align the top edge of the document with the back
edge of the document glass (use the arrow in the top left corner as a guide).
4
Gently close the platen cover.
Caution
When copying a bound document, such as a book, the copied image may contain some
black areas. To reduce this effect, hold down the document to prevent the binding area
from rising. However, do not press too strongly. This may break the document glass
and cause injury.
Note
•
Be sure any correction fluid, ink, or stamps on the document are completely dry
before loading.
•
Be sure that the ADF is empty. If a document has been left in the ADF, the scanner
glass cannot be used.
•
When you load a thick document, do not force the platen cover closed. Doing so may
cause a malfunction.
•
When the cover is open or slightly open while copying, try not look at the light.
•
When scanning is complete, remove documents from the document glass.
1-38
Loading Documents