Network Speed - Axis 5500 User Manual

Configuration Possibilities
Read Back of
information
Example:
Debugging using the
Hex Dump Mode
Example:
Note:

Network Speed

90
The AXIS 5500/AXIS 5550 supports bi-directional printing. The information
from the printer is read back on the parallel port when the parameter Read
Back Port (PRx_IN.) has the default setting of AUTO. However, it is required
that the printer also supports bi-directional printing.
Please refer to your printer documentation for further details regarding bi-
directional printing support.
Follow the instructions below to disable the bi-directional communication for
logical printer PR1:
1. From the print server's internal Web page, select Admin | Logical
Printers.
2. Select the PR1 tab.
3. Set the Read Back Port parameter to NONE.
4. Click the OK button.
When hex dump mode is enabled, the print data is printed as hexadecimal byte
values rather than characters; printer control commands are also printed as hex
values. This allows you to inspect what control and print characters are actually
being sent to the printer, which is a useful debugging facility for more difficult
printing problems.
Follow the instructions below to enable the hex dump mode for PR3:
1. From the print server's internal Web page, select Admin | Logical
Printers.
2. Select the PR3 tab.
3. Set the Hex Dump Mode Enabled radio button to YES.
4. Click OK.
The page length for hex dump printouts is determined by the lines per page
value of the PostScript page format parameter.
With the Network Speed parameter you can manually specify the speed at
which you will send and receive network packages. You can change the
Network Speed setting to correspond to the type of network you are using (10
or 100 Mbit).
To change the Network Speed in an Ethernet network, log in to the print
server's internal Web pages and click Admin | General Settings =>Change.
From here, you have the option of setting the network speed to:

Network Speed

Comment
AXIS 5500 / AXIS 5550 User's Manual