Axis 5500 User Manual page 54

Adding Printers in NetWare
Installing the
Axis Network Print
Server in IP/IPX
Notes:
54
mode. This method is only supported by Axis print servers with firmware version
6.0 and later and only in NDS environments. Pure IP is only supported by
NetWare 5 or higher.
In a Pure IP NetWare environment, the NetWare Administrator should be used
to create the printer, print server and queue objects.
Follow the instructions below:
1. From the print server's internal Web pages, go to Admin | Network
Settings | Detailed View| NetWare.
2. Enter the three PSERVER NDS parameters:
• PSERVER NDS Tree
(example: NW5TREE) or
• PSERVER NDS File Server (IPX only):
(example: FILESERVERNAME) or
• PSERVER NDS Distinguished Name:
(example: AXIS100086.<context>, where <context> is the container
where you want to create your print server)
3. Click OK when finished.
4. Use the NetWare Administrator to create the three needed objects (the
printer, the print server and the queue) in the NDS tree and then link them
together. The Print Services Quick Setup (Non-NDPS) utility can be used
for this. It is available under Tools in the NetWare Administrator.
5. Use the Add Printer Wizard on your workstation to install the printer on your
client.
Additional configuration and management can be performed from any standard
Web browser. Please refer to "Using a Web Browser for Print Server
Management" on page 58.
• If both the IPX and IP protocols are enabled in your network and the print server uses
DUAL_STACK (enabled by default) as its network transport protocol, then IPX will be
chosen. To force the print server to use the IP transport protocol, go to your print server's
Web interface and choose Admin | Network Settings | Detailed View | NetWare and
change the NetWare Transport Protocol from DUAL_STACK to IP_ONLY. Click OK when
finished to save your changes.
• Pure IP requires that you run NetWare 5 or higher.
AXIS 5500 / AXIS 5550 User's Manual