Table of Contents
Advertisement
Hardware Installation
detected by the motherboard. Please re-seat your video card. If
you are using an AGP card, please push your AGP card down real
hard. You may have to push VERY hard without the AGP card
mounting screw. Make sure not to insert the card the other way
around.
•
Continuous beeps – One or more of the memory modules is not
seated correctly in its socket.
My PCI VGA card works fine with my system, but when I put in a
new AGP card, it does not give me any video. Is my AGP slot bad?
This is a common problem with AGP video cards. The reason is that your
AGP card did not get seated into the AGP slot fully and firmly. Please
push your AGP card down into the socket real hard, it should snap twice.
You may have to unscrew the AGP card to allow the card to go further
down. Do take care not to damage the card by using too much force.
I get distorted video with my AGP card right after I save my bios.
Why is that?
The cause is likely that your AGP card is not running at the correct bus
speed. To fix this, please clear the CMOS via JP5 and if it still does not
work, please upgrade your motherboard bios to the latest version.
BIOS Issues
What is the maximum CPU Vcore voltage I can adjust in the BIOS
setup?
•
For 1.65v CPU the maximum you can adjust is 0.200v
•
For 1.70v CPU the maximum you can adjust is 0.150v
•
For 1.75v CPU the maximum you can adjust is 0.100v
This is in accordance to the Voltage Identification (VID) Specification
given by AMD.
Where can I find the BIOS revision of my mainboard?
It will be displayed on the up-left corner on the screen during boot-up. It
will show as your board type followed by the revision number, such as
SY-K7V DRAGON Plus!
48
Advertisement
Table of Contents
