Table of Contents
Advertisement
1.
To delete an array, highlight the Array you wish to delete and press the [Del]
key.
2.
The View Array Definition menu will appear (see below) showing which drives
are assigned to this array.
FastBuild (tm) Utility 1.xx (c) 1995-2000 Promise Technology, Inc.
Array No
Status
Array 1
Stripe Block: 64 KB
Channel:ID
Assignment
1 : Master
2 : Master
3.
Confirm yes to the following warning message with the <Ctrl-Y> key to
continue array deletion:
Are you sure you want to delete this array?
Press Ctrl-Y to Delete, others to Abort
4.
After deleting the array, you should create a new array using Auto Setup or
the Define Array menu from the FastBuild Main Menu.
REBUILDING A MIRRORED ARRAY
The Rebuild Array <5> Menu option is necessary to recover from an error in a
mirrored disk array. You will receive an error message when booting your system
from the FastTrak BIOS.
NOTE : Drives MUST be replaced if they contain any physical errors.
Follow these steps BEFORE using the Rebuild Array menu option:
[ Define Array Menu ]
RAID Mode Total Drv
——
——
[ Drive Assignments ]
Drive Model
QUANTUMCR8.4A
QUANTUMCR8.4A
Capacity(MB)
——
Capacity (MB)
8063
8063
130
——
Y
Y
Advertisement
Table of Contents
