Table of Contents
Advertisement
Creating a Security Array With An Existing Data Drive
NOTE: FastTrak100-Lite permits only two drives to be used for a single Mirrored
array in Auto Setup.
You would use this method if you wish to use a drive that already contains data
and/or is the bootable system drive in your system. You will need another drive of
identical or larger storage capacity.
WARNING: Backup any necessary data before proceeding.
Failure to follow this accepted PC practice could result in data
loss.
WARNING: If you wish to include your current bootable drive
using the Windows NT 4.x or Windows 2000 operating system
as part of a bootable Mirrored (RAID 1) array on your
FastTrak100-Lite, do NOT connect the hard drive to the
FastTrak100-Lite controller yet. You MUST install the Windows
NT4 or 2000 driver first to this drive while it is still attached to
the regular IDE port. For all other Operating Systems, proceed
here.
Follow these steps:
1.
Using the Spacebar, choose "Security" under the Optimize Array for section.
2.
Press <Ctrl-Y> keys to Save your selection. The window below will appear.
Do you want the disk image to be duplicated to another? (Yes/No)
Y - Create and Duplicate
N - Create Only
3.
Press "Y" for the Create and Duplicate option. The window below will
appear asking you to select the Source drive to use. FastBuild will copy all
data from the Source drive to the Target drive.
116
Advertisement
Table of Contents
