Table of Contents
Advertisement
Disable checkbox is checked (the default) to turn off automated
scheduling of synchronization. When unchecked, the Scheduling
section will be highlighted (see above).
On Errors section offers four radio button choices for the user to select
what procedure they would like to perform if an Error is detected
during a scheduled Synchronization. There are three types of
errors that FastTrak100-Lite detects -- a data mismatch between
the primary and secondary drive, a physical media error on source
or target drive, or a total disk failure. The options for handling
Errors are as follows:
Abort : stops the Synchronization process if an error is encountered.
Fix : in most cases, FastTrak100-Lite automatically can correct errors.
The method of correction varies depending on the type of error (see
Appendix under Error Correction Methodology).
Ignore : FastTrak100-Lite will log the event error and continue the
synchronization process. (Warning: this may result in mismatched
drives under RAID 1). Use this setting if you want to detect the
presence of errors, but do not want to fix these errors at the time. The
user may then decide what to do about the error(s) detected.
Interactive : By checking this option, a selection window will appear
each time an error is detected asking the user whether they want to
Abort, Fix, or Ignore the error (see Troubleshooting for more details).
Schedule event drop down box allows scheduling synchronization by minute,
by hour, by day, by week, or by month. If enabled, the default is By
Month. This allows synchronization to take place during an off-hour
when the system is either not in use or not at peak demand.
Start time designates hr/min/ am/pm
On the designates day of week or by ordinal (1st, 2nd, 3rd....) selection.
159
Advertisement
Table of Contents
