2-3.5 Cmos Clear (Jp5); 2-3.6 Power On - SOYO SY-K7V DRAGON Plus User Manual

Hardware Installation

2-3.5 CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the
steps below to clear the CMOS memory.
3. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper
JP5. This jumper can be easily identified by its white colored cap.
4. Then put the jumper back to 1-2 to allow writing of new data into the
CMOS memory.
CMOS
Clearing
JP5 Setting
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.

2-3.6 Power On

You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
Clear CMOS Data
Short pin 2-3 for
at least 5 seconds
to clear the CMOS
SY-K7V DRAGON Plus!
Retain CMOS Data
Short pin 1-2 to
retain new
settings
1 2 3
44
1 2 3