Table of Contents
Advertisement
Page
See
1. Verify that you have already done the following (refer to
2. If you registered the mobile, the Mobile Station ID (phone number) of the mobile
3. Select Page from the list on the left side of the screen.
4. If the mobile responds, you will see the Access annunciator light briefly.
5. Press SEND on the mobile to start the conversation.
6. The Connect annunciator lights. This is the Connect state. Data to be displayed is shown
While the mobile
is being paged,
this annunciator
is lit.
When the mobile's
send button has
been pressed,
this annunciator
is lit.
Figure 23
CALL CONTROL Screen in Connect State
"Program Example" on page 149
Emulate a Base Station" on page 64
•
Zeroed the RF Power meter
•
Put the Test Set in Active state
•
Connected the mobile to the Test Set and turned the mobile's power on
•
Registered the mobile. (See
appears in the MS ID field. Otherwise, you must enter this number.
below.
Chapter 3, Processing Calls
for an example of the program command.
"Configure the Test Set to
):
"Registration" on page 93
)
Page
Con-mode.tif
91
Advertisement
Table of Contents
