HP 83206A User Manual page 45

These fields allow you to enter and enable or disable compensation for any
path loss between the mobile and the PCS Interface's RF IN/OUT port.
Figure 8 Setting the PCS Mode control and entering PCS Interface path losses.
Selecting RF OUT Only as the RF Output Port
When the PCS mode is selected, the RF output of the PCS Interface can be
directed to the RF OUT Only port on the PCS Interface. (The RF input to the PCS
Interface always goes to the RF IN/OUT port.)
To select the RF OUT Only port as the RF output:
1. Access the CONFIGURE screen.
2. Set the PCS Mode field to On.
3. Set the PCS Source field to OUT.
When OUT is selected, the RF Level Offset field's setting is not applied to the
output level.
Chapter 1, Getting Started
About the PCS Interface
This field tells the Test Set to alter its
operation for controlling the PCS Interface.
45