Hard Drive - HP PROBOOK 4520S Maintenance And Service Manual

Hard drive

NOTE: The hard drive spare part kit includes a hard drive bracket.
Description
750-GB, 5400-rpm hard drive
640-GB, 5400-rpm hard drive
500-GB, 7200-rpm hard drive
320-GB, 7200-rpm hard drive
250-GB, 7200-rpm hard drive
Before removing the hard drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the Switch cover and keyboard (see
NOTE:
the hard drive.
6. Remove the palm rest (see
Remove the hard drive:
1. Position the computer right-side up with the front toward you.
2. Remove the two Phillips PM2.5×6.0 screws (1) and loosen the Phillips PM2.5×11.0 captive screw
(2) that secure the hard drive to the computer.
3. Grasp the mylar tab on the hard drive and slide the hard drive (3) to the right to disconnect it
from the system board.
Battery on page
It is not necessary to remove the keyboard cable from the system board when removing
Palm rest on page
55).
Switch cover and keyboard on page
84).
Component replacement procedures
Spare part number
598699-001
617667-001
598698-001
598697-001
598696-001
56).
87