Figure 2-29. Removing The Cpu Module - HP NX9010 Service Manual

3. Slide the front tip of the locking arm slightly to the right and then swing it up and back.
4. Carefully lift the CPU module off of its socket on the motherboard.
HP Pavilion 5300 and 5200, HP nx9010, and Compaq Presario 2500 Models
Reassembly Notes
Caution
Each time you install a new CPU module, you must also replace the heat sink's thermal pad to
maintain optimum heat transfer. Use a sharp knife or scraper to carefully remove the old thermal
pad from the heat sink, then attach the new thermal pad.
•
The CPU module is keyed for installation, and can be inserted only one way.
•
Carefully insert the CPU module into the motherboard, and swing the locking arm forward and
down. Make sure the clip on the right side of the CPU module socket secures the locking arm.
•
Be sure to replace the thermal pad on the heat sink, as described in the reassembly notes on
page 2-47.
Service Manual

Figure 2-29. Removing the CPU Module

Removal and Replacement 2-47