Table 3-7. Bios Setup Menus And Parameters - HP NX9010 Service Manual

3. The pointing devices are not active in BIOS Setup, so you will need to use the keyboard to
navigate:
•
Press the LEFT and RIGHT arrow keys to move among menus.
•
Press the UP and DOWN arrow keys to move among parameters in a menu.
•
Press F5 or F6 to move through values for the current parameter, or press Enter to change a
setting.
4. After you select the options you want, press F10 or use the Exit menu to exit BIOS Setup.
If the settings cause a conflict between devices during reboot, the system prompts you to run BIOS
Setup, and marks the conflicting settings.
Note
The listings in the following table are for the initial BIOS release and might differ somewhat for
other models.
All notebook models: Introduced with BIOS version KE.01.04 (Fall 2002).
Main Menu
BIOS Revision
System Time
System Date
Language
Internal Hard Disk
Extended Memory
CPU Serial Number
Serial Number
PC ID
Service ID
UUID
MAC Address
Service Manual

Table 3-7. BIOS Setup Menus and Parameters

Description
Shows the current BIOS version.
Sets the time using 24-hour format. Values set take effect
immediately.
Sets the date using dd/mm/yy format (except English, which
uses mm/dd/yy format).
Sets the language for BIOS Setup.
Sets the hard disk drive type and various parameters.
Shows the extended memory size.
For a Pentium processor with a serial number, makes the
serial number available to software.
Displays the serial number as shown on the back of the
notebook.
Displays the PC ID String stored in the reserved part of RAM.
Displays an identifier used for repair service.
Displays the value of the 16-byte UUID (Universally Unique
ID) as 32 hex characters.
Displays the MAC network address of the internal (wired)
LAN, if present.
Troubleshooting and Diagnostics
Default
Detected
automatically.
Detected
automatically.
Detected
automatically.
Detected
automatically.
Disabled.
Detected
automatically.
Detected
automatically.
Detected
automatically.
Detected
automatically.
3-27