Figure 2-27. Removing The Heat Sink (With Fan) - HP NX9010 Service Manual

Note
This section applies only to HP Pavilion 5300 and 5200, HP nx9010, and Compaq Presario 2500
models.
Required Equipment
•
#0 Phillips screwdriver.
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. Remove these additional assemblies:
•
Hard disk drive (page 2-9).
•
Keyboard cover (page 2-12).
•
Keyboard (page 2-16).
•
Switchboard PCA (page 2-18).
•
Display assembly (page 2-23).
•
Top case (page 2-26).
3. Disconnect the two fan cables from the motherboard.
4. Remove the four retaining M2.0×5.0 mm screws in the "1", "2", "3", "4" sequence stamped on the
heat sink.
5. Lift up on the heat sink (with fan).
HP Pavilion 5300 and 5200, HP nx9010, and Compaq Presario 2500 Models
2-42 Removal and Replacement

Figure 2-27. Removing the Heat Sink (with Fan)

Service Manual