HP NX9010 Service Manual page 105

Note
This section applies only to HP Pavilion 5300 and 5200, HP nx9010, and Compaq Presario 2500
models.
Required Equipment
•
#1 Phillips screwdriver.
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. Remove these additional assemblies:
•
Hard disk drive (page 2-9).
•
Keyboard cover (page 2-12).
•
Keyboard (page 2-16).
•
Switchboard PCA (page 2-18).
•
Display assembly (page 2-23).
•
Top case (page 2-26).
3. Remove the insulating tape that secures the floppy drive flex cable to the TouchPad bracket on the
top case.
4. Remove the four M2.5×6.0 mm screws that secure the floppy drive and floppy drive bezel to the
top case.
5. Remove the floppy drive.
6. Remove the M2.0×3.0 screw that secures the floppy drive bezel to the floppy drive.
7. Remove the floppy drive bezel.
2-34 Removal and Replacement Service Manual