Power Connector Cable - HP ENVY 14 Maintenance And Service Manual

9. If it is necessary to replace the optical drive connector board:
a. Remove the Philllips PM2.0×2.82 screw (1) that secures the connector board to the
optical drive.
b. Remove the connector board (2).
Reverse this procedure to install the optical drive cable.

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery cover and battery (see
5. Remove the memory module/wireless module compartment cover (see
on page
6. Remove the top cover (see
60 Chapter 4 Removal and replacement procedures
41).
Top cover on page
Battery on page 36).
49).
Spare part number
654170-001
WLAN module