Table of Contents
Advertisement
End IP Address - This field specifies the last address in the IP Address pool.
192.168.0.199 is the default end IP address.
Address Lease Time - Enter the amount of time for the PC to connect to the AP with its
current assigned dynamic IP address. The time is measured in minutes. After the time is up,
the PC will be automatically assigned a new dynamic IP address. The range of the time is 1 ~
2880 minutes. The default value is 120 minutes.
Default Gateway (optional) - Enter the IP address of the gateway for your LAN. The factory
default setting is 192.168.0.254.
Default Domain (optional) - Enter the domain name of your DHCP server. You can leave the
field blank.
Primary DNS (optional) - Enter the DNS IP address provided by your ISP. Consult your ISP
if you don't know the DNS value. The factory default setting is 0.0.0.0.
Secondary DNS (optional) - Enter the IP address of another DNS server if your ISP
provides two DNS servers. The factory default setting is 0.0.0.0.
Click Save to save the changes.
Note:
1)
When the device is working on Dynamic IP mode, the DHCP Server function will be
disabled.
2)
To use the DHCP server function of the device, you should configure all computers in the
LAN as "Obtain an IP Address automatically" mode. This function will not take effect until
the device reboots.
6.7.2
DHCP Clients List
Selecting DHCP > DHCP Clients List will enable you to view the Client Name, MAC Address,
Assigned IP and Lease Time for each DHCP Client attached to the device (Figure 6-21).
ID - Here displays the index of the DHCP client.
Client Name - Here displays the name of the DHCP client.
TL-MR3020
Figure 6-21 DHCP Clients List
-220-
Portable 3G/4G Wireless N Router
Advertisement
Table of Contents
