Setup Wizard (Finding Ip Address Of The Cameras) - TRENDnet TV-IP662WI User Manual

TRENDnet User's Guide

Setup Wizard (Finding IP address of the cameras)

To locate the IP address of your camera(s) on the same network with your PC, please
install the Setup Wizard utility (for Windows only) from the SetupWizard folder .
1. Insert the included CD-ROM into your CD/DVD drive, browse to the CD drive of
the SetupWizard folder and run SetupWizardSetup_1.2.3.4804.msi to begin
the installation wizard.
2. The following screen will show up. Click Next and following the screen to finish
the installation.
3. Click Close to finish the installation.
© Copyright 2014 TRENDnet. All Rights Reserved.
4. Click Start > Programs > TRENDnet > SetupWizard > SetupWizard. The
TRENDnet Setup Wizard appears.
5. Connect an RJ-45 cable from a switch/router to the Ethernet port on the back
of the camera and connect the AC power adapter to the camera. Click Next to
proceed.
6. From the list of cameras that appears, select the camera and click Next to
continue. If your camera is not listed, please ensure your camera is powered on
and connected to the network then click Re-Scan to scan the camera from
your network.
TV-IP662WI
19