Ip Address Filter - TRENDnet TV-IP310PI User Manual

TRENDnet User's Guide
802.1X
Setup 802.1X for remote authentication service.
802.1X Authentication
Enable IEEE Check this box to enable 802.1X authentication
service.
802.1X:
EAPOL version: Extensible Authentication Protocol (EAP) over LAN
(EAPoL). Choose version 1 or 2. This version number
has to match to your 802.1X service EAPOL version.
User Name: Enter the account name.
Password: Enter the password.
Confirm: Enter the password again.
Click Save to save the changes
© Copyright 2014 TRENDnet. All Rights Reserved.

IP Address Filter

Set up a list of clients allow only the clients on the list to access this camera
or to reject clients on the list from access this camera.
IP Address Filter
Enable IP Check this box to enable IP address filtering service.
Address Filter:
IP Address Filter Choose Forbidden to ban the listed IP addresses or
Type: Allowed to allow listed host to access this camera.
Add: Click Add to add a user account
Modify: To modify an entry on the list, highlight the entry by
clicking on it. Then, click the Modify button.
Enter the IP address then click OK
Delete: To delete an entry on the list, highlight the entry by
clicking on it. Then, click Delete
Clear: To clear all entries, click Clear
Click Save to save the changes
TV-IP310PI
35