SATO GL4xxe Series Operator's Manual page 97

WIRELESS LOCAL AREA NETWORK (WLAN) INTERFACE MODE (TABLE 4-9)
MENU
Subnet Mask
XXX.XXX.XXX.XXX
Gateway Address
XXX.XXX.XXX.XXX
MAC Address
XXX.XXX.XXX.XXX
DHCP
Disable*
WLAN SETTING
Signal Strength
Operation Mode
SSID Name
Reset SSID Name
Min Xfer Rate
Channel
Ant. Diversity
Preamble
Power Mgt
Transmit Power
Internat. Mode
Auth Method
Reset WEP Keys
WEP Key 1
WEP Key 2
WEP Key 3
WEP Key 4
Default WEP Key
Signal Strength
255%*
GL408-412e Operator's Manual
Unit 4: Printer Configuration
This menu allows the Subnet Mask for the TCP/IP protocol to be set in four three-digit segments
(SEG1 through SEG4). If the Subnet Mask is assigned by Bootp, ARP, or DHCP, it is dynamic
and read only.
When changing the Subnet Mask, the printer resets the Network Interface Card (NIC) when the
printer is placed online. When the printer resets the NIC, the LCD displays "DO NOT POWER
OFF". After initialization is complete, the LCD displays "E-NET INIT" to signal that the NIC and
printer are in the initialization process. When both the NIC and printer have completed
initialization, the LCD displays "E-NET READY".
The factory default is 000.000.000.000 .
This menu allows the Gateway Address for the TCP/IP protocol to be set in four three-digit
segments (SEG1 through SEG4). If the Subnet Mask is assigned by Bootp, ARP, or DHCP, it is
dynamic and read only.
When changing the Gateway Address, the printer resets the Network Interface Card (NIC) when
the printer is placed online. When the printer resets the NIC, the LCD displays "DO NOT POWER
OFF". After initialization is complete, the LCD displays "E-NET INIT" to signal that the NIC and
printer are in the initialization process. When both the NIC and printer have completed
initialization, the LCD displays "E-NET READY".
The factory default is 000.000.000.000 .
This is an informational screen that displays the manufacturer's assigned number. This number is
unique for each NIC.
Allows the DHCP protocol to be enabled or disabled through this menu.
The factory default is Disable.
Note: Consult with your systems administrator for the appropriate setting.
Is a subset of menus of the INTERFACES mode. Additional menus may be selected form here.
This is an informational screen that displays the factory set signal strength of the wireles interface
and cannot be changed.
DESCRIPTION
4-60