Sequence - Nortel 5399 Hardware Installation Manual

Chapter 3 ROM Monitor Commands
Nortel Networks 5399 Access Switch Hardware Installation Guide
3-22

sequence

The sequence command edits the load/dump interface list. This list
determines the order of the network interfaces the Remote Access
Concentrator will use for loading and dumping. The default, net, uses the
LAN interface. If the Remote Access Concentrator fails to boot using the
first interface, it will try the next interface. The command syntax is:
sequence [–d] | [interface[,interface]. . .]
Specify the LAN interface by selecting net. Separate each interface with
a comma or a space. Enter the interface list as an argument to the
command, otherwise the service port terminal displays a list of available
interfaces and prompts for a new list.
In the following example, interfaces are assigned to the load/dump
sequence list.
monitor:: sequence
Enter a list of 1 to 4 interfaces to attempt to use for
downloading code or upline dumping. Enter them in the order
they should be tried, separated by commas or spaces.
Possible interfaces are:
Ethernet:
SELF:
Enter interface sequence [net]:: self, net
Interface sequence: self,net
If SELF is specified as the first sequencing option, it is
recommended that NET be included as a second sequencing
option as shown in the example above.
net
self