Nortel 5399 Hardware Installation Manual page 83

image
The image command sets and displays the name of the image file
containing the Remote Access Concentrator's software. The syntax is:
image [–d | filename]
The filename argument permits up to 100 characters. To return the image
name to its default, enter a pair of double-quote characters (""). The
default image name is oper.64.enet. The image command display looks
like this:
monitor:: image
Enter Image name: [(ip)"oper.64.enet", \
(mop) "OPER_64_ENET.SYS"]::
Enter TFTP Load Directory [""]::
Enter TFTP Dump path/filename ["dump.192.9.200.88"]::
The image –d command display looks like this:
monitor:: image –d
Image name:Default (ip): "oper.64.enet"
Default (mop):"OPER_64_ENET.SYS"
TFTP Load Directory: ""
TFTP Dump path/filename: "dump.192.9.200.88"
SELF image name: "oper.64.enet"
The SELF image name appears only if the self-boot image is
loaded.
Nortel Networks 5399 Access Switch Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-17