Nortel 5399 Hardware Installation Manual page 62

Chapter 2 Installing the Model 5399 Remote Access Concentrator Module
Nortel Networks 5399 Access Switch Hardware Installation Guide
2-30
Image name: <invalid or uninitialized> Default:
"oper.64.enet"
Enter Image name::oper.64.enet
Image name: "oper.64.enet"
TFTP load directory:
Enter TFTP load directory::/annex
TFTP Dump path/filename: <uninitialized> Default :
"dump.134.117.6.34"
Enter TFTP Dump path/filename::/annex/mydumpfile
Using current TFTP Dump path/filename.
monitor::
3. Issue the following commands to prepare the tftp dump file.
touch /tftpboot/annex/mydumpfile
chmod 622 /tftpboot/annex/mydumpfile
4. Enter the boot command.
The boot command display looks similar to this:
Enter boot file name[oper.64.enet]::
Waiting for Config Block Info...
Requesting boot file "oper.64.enet".
Unanswered requests shown as '?',transmission errors
as '*'.
Requesting boot from 192.9.200.88 via Ethernet...
Booting BFS file using open delay of 8?
Booting TFTP file using open delay of 8
Booting TFTP file from 192.9.200.88
Header received OK. Received data blocks shown as '.'.
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . EOF
Once the Remote Access Concentrator is booted, Monitor Mode is no
longer operational. The Remote Access Concentrator is up and running ,
and the following message is displayed:
Console monitor ready; Press CR to start.