Nortel 5399 Hardware Installation Manual page 80

Chapter 3 ROM Monitor Commands
ROM Software Rev: 1110
Board ID: 64
CPU Type: 486DX2
Memory size: 8 Meg
Flash size: 2 Meg
WAN 1: PRI E1 ETSI
WAN 2: PRI E1 ETSI
SLC 1
SLC SRAM Size: 128 K
SLC 2
SLC SRAM Size: 128 K
Hub Slot Hub CMB HW Rev
10
Nortel Networks 5399 Access Switch Hardware Installation Guide
3-14
config
The config command displays the current configuration information and
revision levels for the Remote Access Concentrator. The config
command displays revision information, the amount of memory installed,
T1 or E1 configuration information, and a description of the number and
type of modems installed. The command syntax is:
config
The config command display for a Remote Access Concentrator with 24
modems (T1) looks similar to this:
REVISION/CONFIGURATION INFORMATION
Board Type: 5399
Ethernet Address: 00-80-2d-xx-xx-xx
EEPROM size: 65504
Flash ID: 0089
Revision: VERSION A MGR=1.159
Revision: VERSION A MGR=1.159
Modem Count: 31
Modem Count: 31
Hub EE Rev
01 0.0
This display is typical for E1 versions. For T1 and modem-less
versions, the information displayed in some of the fields will be
different than that shown in this example.
Modem Rev: 0
Modem Rev: 0
Hub EE Seg Sel Hub Jmpr Seg Sel
N/A 00