Nortel 5399 Hardware Installation Manual page 70

Chapter 3 ROM Monitor Commands
Nortel Networks 5399 Access Switch Hardware Installation Guide
3-4
addr
The addr command displays and sets several Remote Access
Concentrator operating parameters (EEPROM values) relevant to IP
network addressing:
• Internet address.
• Subnet mask.
• Broadcast address.
• Preferred Load Host address.
• Preferred Dump Host address.
• Load/Dump Gateway address.
• Type of IP Packet encapsulation.
• Load Broadcast
The addr -d command displays the unit's ROM-resident Ethernet address
in hexadecimal notation. (For a description of Internet addresses, see the
Remote Annex Administrator's Guide for UNIX.) The command syntax is:
addr [–d]
If you enter the addr command without the –d argument, you will be
prompted for each Internet address. Enter Internet addresses using the
standard decimal dot (.) notation.
The addr –d command displays the Remote Access Concentrator's
Ethernet address, IP address, subnet mask, broadcast address, preferred
load host address, preferred dump host address, load/dump gateway
address, IP encapsulation type, and Load Broadcast flag. The addr -d
command cannot be used to make changes to any of the displayed
parameters.