Powerware 9155 User Manual page 16

UPS SETUP
3.
4.
NOTE Hold the back of the cabinet so that the bolts can be removed easily without the
cabinet rolling backward.
5.
6.
10
EATON Powerware
Remove the front cover from the bottom cabinet to access the
front shipping bracket.
Press and release the handle latch at the bottom of the cover and
then lift the cover up and off the cabinet.
Remove the three M10 bolts securing the rear shipping pad to the
pallet and remove the shipping pad (see Figure 3).
Remove the two M10 bolts securing the front shipping bracket and
remove the bracket.
If needed, adjust the leveling feet to release the bracket.
Front Shipping
Bracket
M10 Bolts
Shipping Pad
Figure 3. Removing the Brackets and Shipping Pad
Reinstall the front cover removed in Step 3.
Hang the top edge of the cover on the cabinet first, then lower the
bottom edge and snap into place.
®
9155 Parallel UPS (8–15 kVA) User's Guide
Stabilizing Bracket
M10 Bolts
M4 Screws
S
164201592 Rev C www.powerware.com