Table of Contents
Advertisement
Installation instructions
18
Connecting the power supply cable
To connect the power supply cable to the
cooker:
Remove the four screws that hold shield "A"
1
behind the cooker.
Open the cable clamp "D" completely.
2
Check the position of the U bolts on the
3
terminal block "B" (Fig. 16a) corresponds to
the connection diagrams in Fig. 16b and
Fig. 16c.
Insert the power supply cable into the cable
4
clamp "D" and into the cable protector
"C". The supply cable must be of a suitable
size for the current requirements of the
appliance.
This cooker must be connected to the
power supply using V105 insulated cable.
This cooker must be earthed.
Connect the phase and earth cables to
5
terminal "B" according to Figs. 16b and 16c.
Tighten the power supply cable and fix it
6
with the cable clamp "D".
Re-mount shield "A", securing it tightly with
7
the four screws.
Note: the earth conductor must be left
about 30 mm longer than the others.
Power supply
220 - 240V ~ 5300W 50Hz
B
C
D
Fig. 16a Accessing the terminal block
1
2
3
4
5
L1
N(L2)
Red or
Red or
Brown
Brown
(Live)
(Live)
Black
Black or
Blue
or Blue
(Neutral)
(Neutral)
Fig. 16b Electrical connection
220-240 V
1 2 3 4 5
L
N (L
1
PE
N
L
Fig. 16c Connection diagram
A
PE
Green
Green
and
and
Yellow
Yellow
(Earth)
(Earth)
)
PE
2
Earth
Neutral
Live
Advertisement
Table of Contents
