Fisher & Paykel OR90 Series Installation Manual
Freestanding cooker
Hide thumbs
Also See for OR90 Series:
- Installation instructions and user manual (44 pages) ,
- Installation manual (23 pages) ,
- Using manual (22 pages)
Related Manuals for Fisher & Paykel OR90 Series
Summary of Contents for Fisher & Paykel OR90 Series
- Page 1 FREESTANDING COOKER OR90 Induction models INSTALLATION GUIDE NZ AU...
-
Page 3: Safety And Warnings
SAFETY AND WARNINGS If the power supply cable is damaged, it must be replaced by the manufacturer, its ● WARNING! service agent or similarly qualified person in order to avoid a hazard. Isolating switch: make sure this cooker is connected to a circuit which incorporates an ●... - Page 4 PARTS SUPPLIED FOR INSTALLATION Anti-tip bracket Screws and plastic and lock pin (1) sleeve anchors (2) TOOLS NEEDED FOR INSTALLATION (NOT SUPPLIED WITH THE APPLIANCE) IMPORTANT! THIS APPLIANCE MUST BE INSTALLED BY A QUALIFIED INSTALLER. Improper installation, adjustment, alteration, services, or maintenance can cause injury or property damage. ●...
-
Page 5: Model Identification
MODEL IDENTIFICATION NOTE: Model features may vary OR90 INDUCTION MODELS OR90SCI1 OR90SCI4 OR90SCI6 OR90SDI6 PRIOR TO INSTALLATION Unpacking and handling Inspect the cooker to verify that there is no shipping damage. If any damage is detected, call the shipper and initiate a damage claim. Fisher & Paykel is not responsible for shipping damage. ●... -
Page 6: Product Dimensions
PRODUCT DIMENSIONS NOTE: Model features may vary Optional kickstrip available (purchased separately) FRONT SIDE OR90SCI MODELS PRODUCT DIMENSIONS Overall height of cooker min 898 max 946 (from floor to top of cooktop, excluding optional backguard) Overall width of cooker Overall depth of cooker (from front of cooker to rear of island trim/backguard, excluding handles and dials) Height of optional backguard from top of cooktop... -
Page 7: Clearance Dimensions
CLEARANCE DIMENSIONS COOKING SURFACE Electrical (see diagrams following) FRONT Note OR90SCI MODELS The cabinetry surrounding the cooker ● CLEARANCE DIMENSIONS must be heat resistant and capable of withstanding temperatures of 75°C Minimum vertical distance between benchtop and cabinet extending above counter above room temperature. - Page 8 FITTING THE OPTIONAL BACKGUARD LOCATION OF ELECTRICAL SUPPLY Backguard (supplied with some models only) Remove the screws and spacers on the rear of the cooktop. ● Assemble the backguard as shown and fix onto the back of the cooker using the ●...
-
Page 9: Ventilation Requirements
VENTILATION REQUIREMENTS A suitable ventilation hood may be installed above the cooker. Fisher & Paykel has a choice of ventilation hoods designed to match the rest of our kitchen appliance family. See fisherpaykel.com or your local dealer for more details. Hood (inc. -
Page 10: Fitting The Adjustable Feet
FITTING THE ADJUSTABLE FEET Fitting the adjustable feet Fitting the adjustable feet covers (optional) The adjustable feet must be fitted to the base of the cooker before use. If using the adjustable feet covers fit these while the cooker is tipped over. Rest the rear of the cooker on a piece of the polystyrene packaging exposing the base for the fitting of the feet. -
Page 11: Moving The Cooker
MOVING THE COOKER IMPORTANT! When raising cooker to upright position always ensure two ● people carry out this manoeuvre to prevent damage to the adjustable feet. Be careful: do not lift the cooker by the oven door handle, the ● hob rail or by lifting the cooktop trim as this may damage the appliance. - Page 12 INSTALLING THE ANTI-TIP BRACKET IMPORTANT! To restrain the cooker and prevent it tipping accidentally secure ● the cooker to the wall using the supplied anti-tip bracket. Make sure you also fit the supplied lock pin to the anti-tip bracket. If installing the cooker above a plinth (without fitting the ●...
- Page 13 INSTALLING THE ANTI-TIP BRACKET Fitting the lock pin (models with a storage/warming drawer) Fitting the lock pin (models with a storage compartment) The anti-tip bracket is accessible by removing the storage/warmer drawer, and is The anti-tip bracket is accessible by opening the storage compartment door., and is positioned on the rear right side of the cooker.
-
Page 14: Electrical Connection
ELECTRICAL CONNECTION IMPORTANT! This cooker must be connected to the mains power supply only by a suitably qualified person. ● This cooker must be earthed. ● If the installation requires alterations to the domestic electrical system, call a qualified electrician. The electrician should also check that the ●... - Page 15 ELECTRICAL FEEDER CABLE CONNECTION IMPORTANT! The power supply cable must be connected by an authorised service person Feeder cable section Use a type of cable according to the applicable local regulations. 220-240 Vac 3 x 10 mm2* *Connection with wall box connection. IMPORTANT! IMPORTANT! Do not to unscrew the...
-
Page 16: Final Checklist
FINAL CHECKLIST TO BE COMPLETED BY THE INSTALLER GENERAL Placement of unit. Specified clearance maintained to cabinet surfaces. Unit Level – front to back, side to side. All packaging material and tie straps removed. Island trim or optional backguard correctly attached. The anti-tip bracket is correctly installed. - Page 20 FISHERPAYKEL.COM © Fisher & Paykel Appliances 2017. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available.