Table of Contents
Advertisement
Fitting the anti-tilt bracket
Important!
To restrain the appliance and prevent
it tipping accidentally, the anti-
tilt bracket and restraining plate
supplied must be fitted according to
the instructions below.
Drill four 8mm diameter holes for
1
the fixing screws (two in the wall
and two in the floor-see Fig.5) and
insert the plastic plugs supplied.
Important!
Before drilling the holes, check that you will not
damage any pipes or electrical wires.
Attach the anti-tilt bracket to the floor and
2
rear wall using the four screws supplied, as
shown in Fig. 5.
After attaching the anti-tilt bracket securely,
3
slide the cooker into place. Ensure that the
rear central foot slides under the bracket, as
shown in Fig.5.
Access the bracket by removing the left
4
drawer (Fig. 6):
Slide out the left drawer completely.
a
Press the lever of the left guide rail
b
down and pull the lever of the right
guide rail up.
Holding the levers, disengage and
c
remove the drawer.
Fix the restraining plate by sliding it into
5
place and securing it with the fixing screw
and washer supplied. See Fig. 7.
Replace the left drawer (Fig. 8):
6
Insert the drawer rails into the guide
a
rails.
Gently push the drawer in
b
completely; the safety catches will
automatically hook.
Important!
Beware of sharp edges when removing or
replacing the drawer.
Installation instructions
Dotted line showing the position
of the cooker when installed
Fig. 5 Attaching the anti-tilt bracket and
Screw & Washer
sliding the cooker into place
Fig. 6 Accessing the anti-tilt bracket
by removing the left drawer
Restraining plate
Fig. 7 Fixing the restraining plate
Fig. 8 Replacing the left drawer
9
Anti-tilt
bracket
Rear central
foot of cooker
Advertisement
Table of Contents
