16-Channel - Lorex LH158 Instruction Manual

• If your system has a 3.5" hard drive, turn the DVR over carefully and loosen the 4 screws
securing the hard drive. Turn the DVR back over and slide the hard drive and lift out of the
DVR. Remove the 4 screws on the bottom of the hard drive.
Loosen the hard drive screws
• If your system has a 2.5" hard drive, turn the DVR over carefully. Hold the hard drive in place
and remove the 4 screws securing the hard drive. Keep holding the hard drive and turn the
DVR back over. Remove the hard drive from the DVR.
Remove the hard drive screws
5 Replace the side and cover panel screws.

16-Channel

Make sure that the power cable has been disconnected before changing the
hard drive.
1 Remove the screws from each side panel (x2) and rear panel (x4) of the cover.
2 Gently slide the cover away from the rear panel and lift off. Be careful of sharp edges.
Appendix E: Replacing the Hard Drive
Slide the hard drive and lift out of the DVR
Make sure to hold the hard
drive in place while
removing the hard drive
screws and turning the DVR
to avoid damaging the DVR.
113