Adjusting Menu Transparency; Adjusting The Video Margin; Adding Privacy Zones - Lorex LH158 Instruction Manual

3 When the DVR restarts, click Yes to
confirm the default resolution.
NOTE: If your system resolution is already
in 1024 x 768, pressing and holding
the Stop button will not restart the
system.

Adjusting Menu Transparency

You can increase or decrease the
transparency of the on-screen menus.
To adjust the transparency of
on-screen menus:
1 Click the Output tab.
2 Drag the Transparency slider to adjust
transparency.
3 Click Apply to save your settings.

Adjusting the Video Margin

If you connect your DVR to a BNC
monitor, you can adjust the video
margins.
NOTE: You must select the BNC output
mode to adjust the margins. Press 0
three times on the remote control to
switch the output mode between
BNC mode and VGA/HDMI mode.
When BNC mode is selected, the
mouse cursor appears on the BNC
monitor.
To adjust the video margin:
1 Click the Output tab.
2 Click the Margin button.
3 Drag the sliders to the left or right to
adjust the Left, Right, Top, or Bottom
Margin.
4 Click Apply to save your settings and click
OK to confirm.

Adding Privacy Zones

A privacy zone allows you to block out
up to 4 portions of each channel with a
black square.
ATTENTION: Areas covered by privacy
zones are not visible in recordings.
To configure a privacy zone:
1 Click the Privacy Zone tab.
2 In the Channel drop-down menu, select
the channel you wish to configure.
Privacy Zone
3 Configure the following:
• Channel: Select the channel you wish to
configure.
• Privacy Zone: Select ON to enable privacy
zones or OFF to disable privacy zones.
• Area Setup: Select the Area1~4
checkboxes to enable up to 4 privacy
zones.
Using the Main Menu
39