Table of Contents
Advertisement
80 | Performance Series HREP2 DVR User Guide
2.
3.
4.
Network Status
From the network map screen, you can check the Internet connection status and camera
connection status, and check also the details of the connection status for each camera.
1.
2.
3.
www.honeywell.com/security
Figure 4-29
Email Settings Screen
Use the
, and ENTER buttons on the remote control or use the mouse to
,
,
,
specify the use of email and select a server.
•
SERVER: Set up the mail server. Set the mail server that will be used for notification to
the DVR. Use the virtual keyboard to enter your mail server.
•
PORT: Enter the mail server port.
•
SECURITY: If it is set to ON, the email will be transferred in secure mode. If it is set to
OFF, the email will be transferred to a server that does not support SSL.
•
USER: Provide the email account (ID) of the sender.
•
PASSWORD: Provide the password of the sender.
•
TEST EMAIL ADDRESS: Enter an email address for the test purpose.
•
TEST: Send a test email and check if the test email is delivered normally.
To apply the change, click APPLY at the bottom of the screen.
When finished, press the EXIT button on the remote control or click CLOSE in the lower
part of the screen. The confirmation message appears and you will return to the previous
menu.
From SYSTEM SETUP
Use the
, and ENTER buttons on the remote control or use the mouse to
,
,
,
select one between NETWORK MAP and DETAIL STATUS.
When finished, press the EXIT button on the remote control or click CLOSE in the lower
part of the screen. The confirmation message appears and you will return to the previous
menu.
NETWORK, select NETWORK STATUS (see
Figure
4-30).
Advertisement
Table of Contents
