Configuring The Network Setup; Configuring Tcp/Ip - Honeywell HRHT4041 Remote User Manual

44 | Performance Series HQA Digital Video Recorder Remote User Guide

Configuring the Network Setup

Configuring TCP/IP

Click TCP/IP in the Network configuration interface to open the TCP/IP configuration interface.
www.honeywell.com/security
Figure 3-10 TCP/IP Configuration Interface
Table 3-5 TCP/IP Configurations
Configuration
IP Version
MAC Address
Mode
Description
Select the IP version, either IPv4 or IPv6.
You can use either version to access the camera's IP address.
Displays the MAC address. This field is not configurable.
There are two modes: STATIC and DHCP.
• The IP address, submask, and gateway is inactive and
not configurable when you select the DHCP mode to
automatically search for the IP address.
• If you select STATIC mode, then you need to manually
configure the IP address, submask, and gateway.
• If you select DHCP mode, then you can only view the IP
address, submask, and gateway. You can not configure
these values.
• If you switch from the DHCP mode to the static mode,
then you need to reset the IP parameters.
The IP address, submask, gateway, and DHCP are read-only
values when the PPPoE dial is OK.