Seat Installation - Pride Mobility JET1 Owner's Manual

SEAT INSTALLATION

WARNING! Do not pick up the seat frame by
the armrests. They are free to pivot, and you
may lose control of the seat if they do so,
resulting in personal injury and/or damage to
the chair.
To install the seat:
1. Set the seat on the seat tower. See figure 8.
2. Push the seat down until the latch engages. See figure 9.
3. Plug the controller harness into the connector on the utility
tray. See figure 10.
CHARGER INHIBIT PLUG CONNECTION
The charger inhibit connector, located on the utility tray, is
coded with colored dots. The dots are positioned so that the
flat side of the male connector aligns with the flat side of the
female connector while making the connection. See figure
11.
WARNING! Failure to properly align the con-
nectors can result in damage to the control-
ler, the charger, and the connectors.
JOYSTICK INSTALLATION
If your Jet 1 is equipped with a Dynamic joystick controller, it
may have been shipped without the joystick installed in the
armrest. See figure 12.
To install the joystick controller:
1. Use a 3/16 in. hex key to loosen the setscrew. See figure 13.
2. Slide the joystick mounting bracket into or out of the arm-
rest to the desired position.
3. Retighten the setscrew by turning it clockwise.
CAUTION! Do not place the controller cable
so that it can be pinched in the seat frame or
the power base frame.
22
V . A S S E M B L Y
www.pridemobility.com
Figure 8. Seat tower
Figure 9. Seat Installation
Figure 10. Controller Harnesses
PLUG IN CONTROLLER HARNESSES
Jet 1/RevD/Jul03