Armrest Angle Adjustment - Pride Mobility JET1 Owner's Manual

V I . C O M F O R T

ARMREST ANGLE ADJUSTMENT

You can adjust the armrest angle to fit your spe-
cific needs. See figure 16.
To change the armrest angle:
1. Lift the armrest straight up so that it is per-
pendicular to the floor.
2. Use a 1/2 in. wrench to loosen the jam nut.
See figure 16.
3. Use a 1/2 in. wrench to loosen the adjusting
screw.
4. Turn the screw clockwise to lower the front
of the armrest, or turn the screw counter-
clockwise to raise the front of the armrest.
5. Lock the adjusting screw into place by tight-
ening the jam nut.
ARMREST HEIGHT ADJUST-
MENT (OPTIONAL)
Your Jet 1 may be equipped with height-adjust-
able armrests.
To change the armrest height:
Loosen the knob located underneath the arm-
rest.
JOYSTICK EXTENSION ADJUST-
MENT
The joystick control can easily slide out away
from the armrest, or in toward the armrest. See
figure 17.
To extend the joystick:
1. Use a 5 mm hex key to loosen the setscrew.
2. Slide the joystick mounting bracket into or
out of the armrest to the desired position.
3. Tighten the setscrew by turning the hex key
clockwise.
Jet 1/RevD/Jul03
A D J U S T M E N T S
TURN THIS
SCREW TO
CHANGE
ARMREST
ANGLE
JAM NUT
LOCKS
ADJUSTING
SCREW IN
PLACE
Figure 16. Armrest Angle Adjust-
ment
LOOSEN
THIS
SETSCREW
TO ADJUST
JOYSTICK
Figure 17. Joystick Extension
www.pridemobility.com 25