Care And Maintenance; General Guidelines - Pride Mobility JET1 Owner's Manual

X . C A R E
ROUTINE MAINTENANCE
Your Jet 1 is a sophisticated power chair. Like any motorized vehicle, it requires routine maintenance checks. You
can perform some of these checks, but others require assistance from your authorized Pride provider. Preventive
maintenance is very important. If you follow the maintenance checks in this section as scheduled, you can help
ensure that your Jet 1 gives you years of trouble-free operation. If you have any doubt as to your Jet 1’s care or
operation, contact your authorized Pride provider.
CAUTION! Your power chair, like most electrical equipment, is susceptible to damage from the
elements. Avoid damp areas of any kind. Direct exposure to water or dampness could cause the
power chair to malfunction electronically and mechanically. Water can cause electrical compo-
nents to corrode and the chair’s frame to rust.
Should your Jet 1 come in contact with water:
1. Dry your Jet 1 as much as possible with a dry towel.
2. Allow your Jet 1 to sit in a warm dry place for twelve hours to allow unseen water to evaporate.
3. Check the joystick operation and the brakes before using your Jet 1 again.
4. If any inconsistencies are found, take your Jet 1 to your authorized Pride provider.
TEMPERATURE
Some of the parts of your Jet 1 are susceptible to extreme changes in temperature. Always keep your Jet 1
between the temperatures of 18° F and 122° F.
n In extremely cold temperatures the batteries may freeze. The specific temperature at which they will freeze
depends on a number of factors, such as battery charge, usage, and composition of the batteries (e.g., sealed
lead-acid or gel cell).
n Temperatures above 122° F may cause your Jet 1 to operate at a reduced speed. This is a safety feature built
into the controller that helps prevent damage to the motor and other electrical components. See VIII. “Opera-
tion.”

GENERAL GUIDELINES

n Avoid knocking or bumping the controller, especially the joystick.
n Avoid prolonged exposure of your Jet 1 to extreme conditions, such as heat, cold, or moisture.
n Keep the controller clean.
n Check all controller connectors on the utility tray to ensure that they are all tight and secured properly. Also
check the charger harness connector.
n When the battery indicator gauge is completely lit, the batteries are fully charged, and the controller and the
electrical system are OK.
n If two red bars on the battery indicator gauge are blinking slowly, the batteries are low and need to be charged,
but the controller and the electrical system are OK.
n If the battery indicator gauge is blinking rapidly, the controller has detected a fault in either its own circuits or in
your Jet 1’s circuits. See VIII. “Operation.”
n Make sure the drive tires are inflated to 30 – 35 psi. See figure 29.
WARNING! Make sure your tires are inflated to 30-35 psi. Do not underinflate or overinflate your
tires. Low pressure may result in loss of control, and overinflated tires may burst. Serious personal
injury may result. Overinflating tires can cause them to explode and can result in personal injury.
38
A N D M A I N T E N A N C E
www.pridemobility.com Jet 1/RevD/Jul03