Seat Installation - Pride Mobility Go-Chair Owner's Manual

I V . A S S E M B L Y / D I S A S S E M B L Y

SEAT INSTALLATION

It may be necessary to install the seat either prior to initial
operation or after transporting your Go-Chair. The seat is
attached to the power base by a height-adjustable seat
pedestal.
WARNING! Do not pick up the seat
frame by the armrests. They are free to
pivot, and you may lose control of the
seat if they do so, resulting in personal
injury and/or damage to the chair.
To install the seat:
1. Adjust the seat height if necessary. See V. “Comfort
Adjustments.”
2. Set the seat onto the seat pedestal. See figure 9.
3. Install the controller into the armrest and tighten the
setscrew under the armrest.
4. Plug the controller connector into the power base. See
figure 6.
DISASSEMBLY
The Go-Chair disassembles into four components: the seat,
the battery box, the rear section of the power base and the
front section of the power base. See figure 10.
To disassemble the Go-Chair:
1. Turn off power to the controller. See VII. “Operation.”
2. Place the Go-Chair in drive mode. See III. “Your Go-Chair.”
3. Disconnect the controller from the power base.
4. Remove the seat.
5. Lift the battery box off of the power base.
6. Push in the toggle latch release button while pulling forward
on the toggle latch. See figure 11.
7. Rotate the toggle latch buckle over the top of the toggle latch
until it snaps into its retainer. See figure 12.
8. Lift the front section up and off of the rear section.
NOTE: Assemble the Go-Chair in the reverse sequence.
Go-Chair
Figure 9. Seat Installation
www.pridemobility.com 19