To reduce the possibility of shipping damage, your Jet 1s seat is removed from the power base, and the seat back
is removed from the seat assembly before your Jet 1 is shipped. The joystick may also have been removed from
the armrest. The following is a set of instructions to help you quickly and easily prepare your Jet 1 for immediate
use.
Required Tool: Phillips screwdriver
Parts List
Phillips-head seat back mounting screws
Knobs - arm width adjustment
Expandable arm
Expandable arm with joystick
Seat-back
8 in. wire ties
SEAT-BACK ASSEMBLY
The seat-back mounts to the back hinges with four (4) Phillips-head screws. To get to the hinges, lift up the
reusable fastener flap which covers them in the back. You may install the seat-back before or after you install the
seat to the power base.
To mount the seat-back to the hinge:
1. Line up the hinges with the holes in the seat-back. See figure 7.
2. Insert the seat-back mounting screws through the hinge and into the seat-back.
3. Tighten the four screws.
Jet 1/RevD/Jul03
V .
A S S E M B L Y
Quantity
4
2
1
1
1
4
Figure 7. Seat-back Assembly
www.pridemobility.com
SCREWS
21