Pride Mobility JET1 Owner's Manual page 19

UTILITY TRAY
The utility tray is located on the rear of your Jet 1. The utility tray is exposed through the body shroud. The utility
tray consists of the battery charger cord, the ammeter, the main circuit breaker, the controller harness connectors
and the power seat connector.
n Ammeter: The ammeter displays the chargers current output in amps. See figure 4. For more information, see
IX. “Operation.”
n Battery charger power outlet: This is where your battery charger power cord plugs in. See figure 4. The
battery charger power cord is not attached to the unit at all times. See figure 3b. For more information, see
IX. “Batteries and Charging.”
n Main circuit breaker: The main circuit breaker is a safety feature built into your Jet 1. See figure 4. When the
batteries and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker will trip to
prevent damage to the motors and the electronics. If the circuit trips, allow your Jet 1 to “rest” for approxi-
mately one minute. Next, push down the circuit breaker button, turn on the joystick controller and continue
normal operation. If the main circuit breaker continues to trip repeatedly, contact your authorized Pride pro-
vider.
n Controller Harness Connectors: This is where the joystick connects to the motors, batteries, and charger.
If your Jet 1 is equipped with a Dynamic controller, there are two connectors on the tray. See figure 4.
BATTERY CHARGER
POWER OUTLET
Figure 4. Utility Tray
Jet 1/RevD/Jul03
I V . T H E
AMMETER
MAIN CIRCUIT BREAKER
www.pridemobility.com
J E T 1
CONTROLLER HARNESS
CONNECTORS
19