Completing The Installation - IBM x3630 M4 Type 7158 Installation And User Manual

Completing the installation

To complete the installation, complete the following steps:
1. If you removed the air baffle, install it (see "Installing the air baffle" on page 90).
2. If you removed the PCI riser-card assemblies, replace the riser-card assemblies
3. If you have the optional hot-swap rear hard disk drive cage installed, rotate it
4. If you removed the server top cover, replace it (see "Installing the server top
5. Install the server in a rack. See the Rack Installation Instructions that come with
6. To attach peripheral devices and connect the power cords, see "Front view" on
(see "Installing the PCI riser-card assembly" on page 90).
down (see "Rotating the optional hot-swap rear hard disk drive cage down" on
page 93).
cover" on page 93).
the server for complete rack installation and removal instructions.
page 12.
Note: Remember to route the power cord through the cable retainer clip so that
it does not accidentally become disconnected.
Chapter 2. Installing optional devices
89