Light Path Diagnostics Panel - IBM x3630 M4 Type 7158 Installation And User Manual

v Reset button: Press this button to reset the server and run the power-on

Light path diagnostics panel

Note: The initial server configuration will not include the light path diagnostics
panel. It is included when the operator information panel is upgraded to the
advanced operator information panel.
The light path diagnostics panel is located on the top of the advanced operator
information panel.
To access the light path diagnostics panel, press the blue release latch on the
advanced operator information panel. Pull forward on the panel until the hinge of
the operator information panel is free of the server chassis. Then pull down on the
panel, so that you can view the light path diagnostics panel information.
The following illustration shows the LEDs and controls on the light path diagnostics
panel.
16
System x3630 M4 Type 7158: Installation and User's Guide
self-test (POST). You might have to use a pen or the end of a straightened paper
clip to press the button.
Note: Depending on the type of operator information panel installed in your
server, the Reset button is on the operator information panel or the light path
diagnostics panel.