Table of Contents
Advertisement
10. Orient the fan so that the fan cable points to the system board.
11. Lower the fan into the fan slot in the server and ensure that is it seated
12. Connect the system fan cable to the connector on the system board.
13. Insert the system fan cable into the cable retainer clip.
14. Return the blue handle back to its horizontal position.
15. If you have other devices to install or remove, do so now. Otherwise, go to
Installing Fan 2A or 3A:
1. Orient the fan so that the fan cable points to the system board.
2. Lower the fan into the fan slot in the server and ensure that is it seated
3. Connect the system fan cable to the connector on the system board.
4. Insert the system fan cable into the cable retainer clip.
5. If you have other devices to install or remove, do so now. Otherwise, go to
Installing a memory module
The following notes describe the types of dual inline memory modules (DIMMs) that
the server supports and other information that you must consider when you install
DIMMs:
v To confirm that the server supports the DIMM that you are installing, see
v When you install or remove DIMMs, the server configuration information
v The server supports only industry-standard double-data-rate 3 (DDR3), 1066,
9. Pull up the blue handle on the system fan cage.
correctly.
"Completing the installation" on page 89.
correctly.
"Completing the installation" on page 89.
http://www.ibm.com/systems/info/x86servers/serverproven/compat/us/. for a list of
supported memory modules for the server.
changes. When you restart the server, the system displays a message that
indicates that the memory configuration has changed.
1333, or 1600 MHz, synchronous dynamic random-access memory (SDRAM)
registered dual inline memory modules (DIMMs) with error correcting code
(ECC).
Chapter 2. Installing optional devices
71
Hide quick links:
Advertisement
Table of Contents
