Installing A Hot-Swap Power Supply - IBM x3630 M4 Type 7158 Installation And User Manual

Installing a hot-swap power supply

The following items describe the type of power supply that the server supports and
other information that you must consider when you install a power supply:
v To confirm that the server supports the power supply that you are installing, see
v The server comes standard with one 550-watt or 750-watt hot-swap power
v These power supplies are designed for parallel operation. In the event of a
v The server can run fully configured with one power supply. For redundancy
Note: You cannot mix high-efficiency and non-high-efficiency power supplies in the
server.
Statement 5:
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
Statement 8:
84
System x3630 M4 Type 7158: Installation and User's Guide
http://www.ibm.com/systems/info/x86servers/serverproven/compat/us/.
supply. The input voltage is 110 V ac or 220 V ac auto-sensing.
Note: You cannot mix 110 V ac and 220 V ac, or 550-watt and 750-watt power
supplies in the server, it is not supported.
power-supply failure, the redundant power supply continues to power the system.
The server supports a maximum of two power supplies.
support, you must install the second hot-swap power supply.