What Your Server Offers - IBM x3630 M4 Type 7158 Installation And User Manual

Table 1. Features and specifications (continued)
Environment (continued)
v Design to ASHRAE Class A3, ambient
of 35°C to 40°C, with relaxed support:
– Support cloud like workload with no
performance degradation acceptable
(Turbo-Off)
– Under no circumstance, can any
combination of worst case workload
and configuration result in system
shutdown or design exposure at
40°C
v Particulate contamination:
Attention: Airborne particulates and
reactive gases acting alone or in
combination with other environmental
factors such as humidity or temperature
might pose a risk to the server. For
information about the limits for
particulates and gases, see "Particulate
contamination" on page 127.
Electrical input with hot-swap ac power
supplies:
v Sine-wave input (50 ~ 60 Hz) required
v Input voltage range automatically
selected
v Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v Input kilovolt-amperes (kVA)
approximately:
– Minimum: 0.22 kVA
– Maximum: 0.85 kVA

What your server offers

The server uses the following features and technologies:
v Features on Demand
v Integrated Management Module II
v UEFI-compliant server firmware
Size:
v 2U
v Height: 86.5 mm (3.406 in.)
v Depth:
– EIA flange to rear: 720.2 mm (28.35
in.)
– Overall: 748.8 mm (29.5 in.)
v Width:
– With top cover: 447 mm (17.598 in.)
v Weight: approximately 16.4 kg (36.2 lb)
to 28.2 kg (62.2 lb) depending on your
configuration
If a Features on Demand feature is integrated in the server or in an optional
device that is installed in the server, you can purchase an activation key to
activate the feature. For information about Features on Demand, see
http://www.ibm.com/systems/x/fod/.
The integrated management module II (IMM2) is the second generation of the
IMM. The IMM2 is the common management controller for IBM System x
hardware. The IMM2 consolidates multiple management functions in a single chip
on the server system board.
Some of the features that are unique to the IMM2 are enhanced performance,
expanded compatibility with blade servers, higher-resolution remote video,
expanded security options, and Feature on Demand enablement for hardware
and firmware options.
For additional information, see "Using the integrated management module II" on
page 106.
System fans: Up to three
Hot-swap power supplies (depending on
the model):
v Up to two hot-swap power supplies for
redundancy support
– 550-watt ac
– 750-watt ac
Note: You cannot mix high-efficiency and
non-high-efficiency power supplies in the
server.
Acoustical noise emissions:
v Sound power, idle: 6.6 bel
v Sound power, operating: 6.6 bel
Chapter 1. The System x3630 M4 Type 7158 server
7